This is the default setting that we recommend for most systems. On the Configuration tab of the UAD Control Panel under the "UAD-2 DSP" section, make sure that "Limit DSP load to" is set to the maximum value (100%). There are a handful of settings we can adjust in the UAD Meter & Control Panel that will affect the performance of all of our device categories (PCIe cards, Satellites, and Apollo interfaces). Optimizing the UAD Meter & Control Panel (all devices) Note: UAD-2 Satellites and PCIe cards cannot be used to process UAD plug-ins in Apollo's Console. In the short term, however, there are a few strategies you can use to squeeze the most DSP power out of your existing setup as possible. We've all been there before - you're almost done with the final mix of your latest session and you reach for one last UAD plug-in to seal the deal, but alas - no more DSP is available! In the long run, this may be a good indication that another Apollo, Satellite, or PCIe card would be a good addition to your setup to maximize the number of simultaneous UAD plug-ins you can use.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |